1. Home
  2. Cisco Systems
  3. SNMP Trap Link-Status

SNMP Trap Link-Status

I'm trying to turn off 'SNMP Trap Link-Status' on a 4500 with IOS 12.2 When I try to use this command 'no snmp trap link-status' in a 'interface range' on a module, I get this error:

% Range command terminated because it failed on FastEthernet4/1

I can use this command on each indivual port and works fine but not on a interface range.

Any Ideas?

Thanks

Reply to
Greg
Loading thread data ...

interface range is not supported on all Cisco models. Usually on supported on later L3 switches

Reply to
Merv

interface range is not supported on all Cisco models. Usually on supported on later L3 switches

Reply to
Merv

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.