1. Home
  2. Cisco Systems
  3. Cisco 878

Cisco 878

Hi all

I'm having trouble with an 878 SHDSL modem My startup config for the controller is

controller DSL 0 mode atm line-term cpe line-mode auto dsl-mode shdsl symmetric annex B line-rate 2048

Yet when I start the modem up the line rate changes to 1152

Show running

controller DSL 0 mode atm line-term cpe line-mode auto dsl-mode shdsl symmetric annex B line-rate 1152

I have to manually go in via the console cable and change the line-rate to 2048 before the modem will give me a connection

Any ideas please as to why it doesn't keep the settings in the startup config

Reply to
Super Slueth
Loading thread data ...

Hate to ask the obvious, but you are doing a write mem or copy run start right?

Reply to
Trendkill

Or have you tried line-rate auto? I'm having trouble finding any clear documentation that says you can or can't change that parameter, so I'm wondering if its a code issue or if auto might work.

Reply to
Trendkill

copy run start

Reply to
Super Slueth

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.