3560 switch / router

Jan 31, 2007 1 Replies

Rate this thread:

a 19 years ago

Hi,

Before I enable the routing of the 3560, I use ip default-gateway to point the traffic to an external router. I am able to telnet to it. After I turn on the routing by ip routing, router rip, network A.B.C.D, I am not able to telnet or ping it anymore from outside. What should I do?

Thanks

Vote

Tom 19 years ago

You'd want to put in: ip route 0.0.0.0 0.0.0.0 A.B.C.D

Fo rmore info, have a look at the Cisco document:

formatting link

Tom

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required