Is there anyone who knows how i can trigger output 1 at ademco vista
12B to indicate the arm state? without the use of anyother optional module? thanks ;-)
12B to indicate the arm state? without the use of anyother optional module? thanks ;-)
Vista 12B outputs
Jun 05, 2011
5 Replies
12B to indicate the arm state? without the use of anyother optional module? thanks ;-)
If the 12B is anything like the Vista /15/20, it would have a header somewhere in the middle of the circuit board where two programmable open collector outputs are available. #17 & #18
=F0=E1=F1=DC=E8=E5=F3=E7 -
it's about the same panel. i cannot locate the address at programmibg form to programm those 2 pins.
In the Vista 15/20 programming sheet, it's at address 80.
Yes it is clearly laid out in the installation manual
Yap thank you. I did it. I trigger onboard outputs 17 & 18 with keyswitch. Thank you.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required