Problems with an Ademco Vista-15... System won't arm, and it keeps counting?

iratable · 2007-02-06T21:50:38+00:00

Hoping someone might have run into this problem before. I've got a 5-year old Ademco Vista-15 which refuses to arm.The control pad -- a fixed-word display -- has a "check" statusindicator on, and the alphanumeric section where I would expect to seezone data is counting from 49 to 63, then starting over again. (Andover and over and over.)When tripping the sensors (total of 2 motion + 3 door) the control padis correctly identifying the zones that are being triggered. Inputingthe master code to turn the system off, place it in test mode, adjustother codes, or anything else for that matter seems to have no effect.Anybody run into something like this before? Could it be a simplematter of replacing a battery or something? (I couldn't find anydescriptions via Google that matched my problem, so I'm not so sure.)Many thanks in advance for the help...

Feb 06, 2007 20 Replies

Rate this thread:

Roland 19 years ago

I think that if you really break this down to basics, all women really want is a credit card with a penis.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required