I will be swapping out a NT5D12AD card that has two loops (56 & 57). I know I will need to DISL both loops, compare/the switches/jumpers on both card. Once I have the new card in, other than ENLL the two loops, are there any other commands I will need to do (any MSDL commands)?
Replacing NT5D12
Jan 18, 2006
1 Replies
If it is Pri you will have to disable the D-Channels in 96 first then disable the loops if the D-Channels are set to auto they should come back on their own.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required