Does anyone have a tutorial or anything showing what needs to be configured on the netscreen appliance in order to connect using the NetScreen remote con client? Been so long I don't remember how to set it up on the appliace itself.
Okay so I got past Phase 1. Phase 2 is giving me some trouble Getting the following error on the netscreen appliance:
Rejected an IKE packet on untrust from x.x.x.x:500 to x.x.x.x:500 with cookies f0524f055621fee9 and a9a9b3f0f3cac4b8 because the peer sent a proxy ID that did not match the one in the SA config.
Any ideas on this?
A Proxy ID mismatch is usually a result in source / destination addresses not matching with in the policy. Check to make sure your destination in the remote client matches what you are allowing inbound on the dialup VPN policy.
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.