Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

oob managament / dial- in into 2610

Hi! I want to configure a 2610 with BRI card and ASYNC16 to work as an out-of-band-management station. Everything works...
2 comments posted 21yrs
posted by lox
2 comments posted 21yrs posted by lox

Catylyst 4507r power down

Is there a particular sequence to powering down a cat 4507r w/supIV engine when connected to cisco 2800 series router a...
0 comments posted 21yrs
posted by fgarza
0 comments posted 21yrs posted by fgarza

Softphone LAN QoS CONFIG

Hi, I'll appreciate if anyone out there could send me a QoS Layer II config when Cisco softphones are being used in a bi...
1 comments posted 21yrs
posted by nkhwaja
1 comments posted 21yrs posted by nkhwaja

4500 "Image Management Port"

The docs say: "The Cisco Catalyst 4500 Series Supervisor Engine II-Plus-TS includes a dedicated 10/100 copper RJ-45 man...
1 comments posted 21yrs
posted by boydjw
1 comments posted 21yrs posted by boydjw

OK for Default Gateway to be in Different Subnet?

I'm helping some folks with their network and I want to make minimal changes to it. Their IP address scheme is inconsis...
12 comments posted 21yrs
posted by bobneworleans
12 comments posted 21yrs posted by bobneworleans

Gre through PIX 515E

Hi, I have a PIX515E, 5.3(2). I applied access-lists to permit only gre protocol between two stations (one from LAN, on...
1 comments posted 21yrs
posted by vinan.xinxn
1 comments posted 21yrs posted by vinan.xinxn

police problem on 3550

Hi Cisco 3550 IOS 12.1(22) I try limit bandwidth to 64kbit/s for 3 hosts. Why does it not work ? class-map match-any ten...
0 comments posted 21yrs
posted by bender
0 comments posted 21yrs posted by bender

combining c700 & c800 with CHAP

Hi, Can anybody tell me, wether I can combine a c700 and a c800 when running CHAP? Specially with calls going from c800...
0 comments posted 21yrs
posted by naam
0 comments posted 21yrs posted by naam

Pix Outside NAT

Hi, I have a pix that connects to 2 internet links. I want to split different types traffic across the 2 links in each...
3 comments posted 21yrs
posted by bitored2002
3 comments posted 21yrs posted by bitored2002

Catalyst 2960 and Catalyst Express 500

Hi I would like to hear if anybody has got any experience with these new modells: http://www.cisco.com/go/catalystexpres...
0 comments posted 21yrs
posted by dont_spam_me_rgiana
0 comments posted 21yrs posted by dont_spam_me_rgiana

Newbie question C837

Hi, I have a C837 and I want to only allow certain IP addresses from the LAN through to the Internet. Do I apply the ac...
15 comments posted 21yrs
posted by SW
15 comments posted 21yrs posted by SW

Dynamic Site to Site

I have a static site to site vpn tunnel between a pix 515 and a 506. I now need to add a dynamic site to site vpn tunne...
6 comments posted 21yrs
posted by morgan.ian
6 comments posted 21yrs posted by morgan.ian

PIX PPTP stops working.....

Hello All, I have a PIX 515-R unit running 6.3(3) and just today after running fine for about 2-3 months, the PIX stopp...
0 comments posted 21yrs
posted by michael_shiah
0 comments posted 21yrs posted by michael_shiah