Cisco Systems

  1. Home
  2. Cisco Systems
14705 Threads Posts
to

Worth reading in Cisco Systems

Bandwidth Utilization for PIX Rookie

Hi, I've inherited a PIX 506e at a new client. I've learned enough to setup the PIX handing out DHCP addresses and allo...
1 comments posted 20yrs
posted by langley101
1 comments posted 20yrs posted by langley101

PCI - Four Port COM Card

I thought that you folks might know the answer to this, though it is a little off topic. I am looking for a cost effect...
0 comments posted 20yrs
posted by fatkinson
0 comments posted 20yrs posted by fatkinson

Minimum feature set for MLFR?

I need to support Multi-link frame relay. Do I need more than IP Plus?
1 comments posted 20yrs
posted by kilbyfan
1 comments posted 20yrs posted by kilbyfan

Swapping a 828 - default access

I am trying to swap a faulty Cisco 828 - did a TFTP backup of the running config and put the new cisco in. But it does...
4 comments posted 20yrs
posted by none
4 comments posted 20yrs posted by none

Finding what ports on Cat switch are trunks

I have many Catalyst switches that I am polling with SNMP. I am trying to find what ports are acting as trunks. On most...
2 comments posted 20yrs
posted by pzaloum
2 comments posted 20yrs posted by pzaloum

SNMP on 3500XL

I need to configure on 1 of my switches. Just wondering if setting it up would require a restart of the switch? or will...
1 comments posted 20yrs
posted by ZooOYork
1 comments posted 20yrs posted by ZooOYork

Switching ISPs

I am hoping someone can critique this. I am in the process of switching ISPs, as one of them has lots of outage issues....
7 comments posted 20yrs
posted by BunsOfSt33l
7 comments posted 20yrs posted by BunsOfSt33l

TFTP Server, which one?

Hi all. The Solarwinds TFTP server won't start on my PC, pops up an error that there's already a TFTP server running (t...
2 comments posted 20yrs
posted by speichts
2 comments posted 20yrs posted by speichts

Pix 515e and Nortel i2050 Softphone

We are in the process of configuring our PIX 515e to allow remote access to Nortel i2050 Softphones. In the process, we...
2 comments posted 20yrs
posted by cjoles
2 comments posted 20yrs posted by cjoles

Failover with two switches ..

Hi, I have two switches (a 2950 and a slightly older one I think), I've a small LAN behind two 515e's (in failover mode...
8 comments posted 20yrs
posted by danny
8 comments posted 20yrs posted by danny

VPN question

Hi there, I have Pix Firewall 6.2(1) and Cisco VPN client 4.0c. Some clients are not able to connect using their home I...
4 comments posted 20yrs
posted by CalinGuga
4 comments posted 20yrs posted by CalinGuga

GRE high availability with HSRP routers

Cisco documentation about IPSec stateful failover shows it IS possible to use gre tunnels with a couple of HSRP configu...
7 comments posted 20yrs
posted by profile0104
7 comments posted 20yrs posted by profile0104

HSRP on Catalyst

I need to enable HSRP across two core 6513. We need this for two voice gateways so there will be 2 HSRP groups. Most of...
5 comments posted 20yrs
posted by mike.lydick
5 comments posted 20yrs posted by mike.lydick

asa 5510 to Catalyst 2950 vlan and trunking

Does anyone have any idea where to start with using vlans with a combination of the ASA5510 and the Catalyst 2950? I nee...
1 comments posted 20yrs
posted by kbtechnow
1 comments posted 20yrs posted by kbtechnow