Cisco Systems

  1. Home
  2. Cisco Systems
14701 Threads Posts
to

http authentication against radius

hello I am trying to make some catalyst switches talk to the Radius server available in MS Windows 2003; called the Int...
4 comments posted 18yrs
posted by rl
4 comments posted 18yrs posted by rl

PPP multilink problem

Hi Guys, i got a situation here and hope someone will be able to help me out. Recently i configured a PPP multilink and...
1 comments posted 18yrs
posted by dabance
1 comments posted 18yrs posted by dabance

PIX to PIX VPN?

I am having an issue connecting a PIX to PIX VPN. The remote site config is listed below. I am new to this and have bee...
2 comments posted 18yrs
posted by jonsey1222
2 comments posted 18yrs posted by jonsey1222

Lots of ASA 5505 throttle questions

Is it possible to throttle a given internal IP address to some maximum bandwidth? I have a 3 Mbit/s link and I want to...
1 comments posted 18yrs
posted by noah
1 comments posted 18yrs posted by noah

RIPng vs. RIPv2 (Stange Differences) ?????

Hello, I am using RIPng (RIP Next Generation). I am comparing it with RIPv2 (RIP for IPv4) and I found some differences...
2 comments posted 18yrs
posted by egamess
2 comments posted 18yrs posted by egamess

error multiple uses of access control list

Hi All: I've been able to further clean out my config, but I'm still getting the error above when I try to open PDM on...
2 comments posted 18yrs
posted by devnull
2 comments posted 18yrs posted by devnull

asa routing

Hi, where is my bug? I can't reach the outside interface from the inside... i must build it without nat. interface insi...
4 comments posted 18yrs
posted by scheurer
4 comments posted 18yrs posted by scheurer

very simple cisco switch question

hi guys why is it after i telnet into my cisco switch (3500) if i press "Set ?" it says "unrecognized command" ive trie...
7 comments posted 18yrs
posted by mina.moussa
7 comments posted 18yrs posted by mina.moussa

Multiple Site-to-site VPNs

Greetings, I recently tried to get multiple site to site off one PIX ver 6.3 working. (Other sites are pix 6.3 as well)...
2 comments posted 18yrs
posted by ceykooutveriz
2 comments posted 18yrs posted by ceykooutveriz

can't delete ACL

Hi All: I was trying to clean out some old configuration lines in my 506e (6.3.(4)) config prior to setting up a pix-to...
2 comments posted 18yrs
posted by whome
2 comments posted 18yrs posted by whome

4500 switch line cards oversubscription

I have some 48 port line cards in 4506 switch and I cannot found wich ports makes one group that sharw bw. Is there a co...
2 comments posted 18yrs
posted by read.from
2 comments posted 18yrs posted by read.from

Add second WIC to 2612XM

I'm having TWTelecom add a second T1 to our circuit so I need to install a second WIC card in the router. What config i...
2 comments posted 18yrs
posted by cwhitmore
2 comments posted 18yrs posted by cwhitmore

traffic shaping w/ router as a transparent bridge

Ive got some issues with traffic shaping, I assume Im just missing something stupid but cant seem to find the issue. Im...
5 comments posted 18yrs
posted by msbrentlinger
5 comments posted 18yrs posted by msbrentlinger