Hi all:
We have a Cisco 2811 in India that I would like to create a VPN tunnel with our Watchguard Firewall in the US, here is the show ver of the router:
Cisco IOS Software, 2800 Software (C2800NM-ADVSECURITYK9-M), Version
12.4(9)T, RELEASE SOFTWARE (fc1) Technical Support:ROM: System Bootstrap, Version 12.4(1r) [hqluong 1r], RELEASE SOFTWARE (fc1)
eagleindia uptime is 2 hours, 40 minutes System returned to ROM by reload at 17:53:04 PCTime Fri Aug 18 2006 System restarted at 17:54:45 PCTime Fri Aug 18 2006 System image file is "flash:c2800nm-advsecurityk9-mz.124-9.T.bin"
This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
Cisco 2811 (revision 53.51) with 249856K/12288K bytes of memory. Processor board ID FHK1014F1PU
2 FastEthernet interfaces 1 Serial(sync/async) interface 1 Virtual Private Network (VPN) Module DRAM configuration is 64 bits wide with parity enabled. 239K bytes of non-volatile configuration memory. 62720K bytes of ATA CompactFlash (Read/Write)Can anyone show me where to get started? sample config? never done this before.
TIA.