Hi, I was wondering if anyone knew how to get an Aironet AP1120B up and running again when it fails to boot. I upgraded the software and it successfully booted the first time, then i screwed up the configuration and pressed the "reset" button to remove the config and start again now the AP doesn't boot anymore. Since there is no console port I'm a bit lost, is there really no way to recover from this?
-SAto
You may wish to investigate Cisco Aironet 1100 Series Troubleshooting.
Reloading the Access Point Image
Brad Reese BradReese.Com - Cisco Network Engineer Directory
BradReese.Com=AE - Leverage Your Cisco Network skrev:
It sure did, thanks!
I've been searching for this but came up blank. (at first I was blind, but now I can see) Thought there had to be a way to do this, and as it turns out there was.
Thanks again!
-SAto
Have something to add? Share your thoughts — no account required.
Ask the community — no account required
