Slow Boot

After reloading my router (2691) router reloading about 10-15 min!! When I plug a console cable I saw that after loading bootstrap (first in flash image) router loop a long time... No messages and other suspicious things on screen... ?! Any ideas? How to check why is this long waiting before ... After reloading no problems... Hardware check (without send to service)?

TIA Here is output:

System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1) TAC Support:

formatting link
(c) 2002 by cisco Systems, Inc. c2691 processor with 262144 Kbytes of main memory Main memory is configured to 64 bit mode with parity disabled

Readonly ROMMON initialized program load complete, entry point: 0x80008000, size: 0xb2a0 program load complete, entry point: 0x80008000, size: 0xb2a0

program load complete, entry point: 0x80008000, size: 0xeaae50 Self decompressing the image : ################################

Smart Init is disabled. IOMEM set to: 25

Using iomem percentage: 25 Uncompressed configuration from 6262 bytes to 18162 bytes If the interface doesn't support baby giant frames maximum mtu of the interface has to be reduced by 4 bytes on both sides of the connection to properly transmit or receive large packets. Please refer to documentation on configuring IEEE 802.1Q vLANs.

!!!!!!!!!!!!!!!!!!!!!!!!!!!! A long long long waiting.... !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

program load complete, entry point: 0x80008000, size: 0x228b500 Self decompressing the image : ##########################################

Smart Init is disabled. IOMEM set to: 25 .......

here boot section (with 12.4(10) same )

boot-start-marker boot system flash c2691-adventerprisek9-mz.124-9.T1.bin boot-end-marker

here show version: Router#show ver Cisco IOS Software, 2600 Software (C2691-ADVENTERPRISEK9-M), Version

12.4(9)T1, RELEASE SOFTWARE (fc2) Technical Support:
formatting link
(c) 1986-2006 by Cisco Systems, Inc. Compiled Wed 30-Aug-06 16:03 by prod_rel_team

ROM: System Bootstrap, Version 12.2(8r)T2, RELEASE SOFTWARE (fc1)

Router uptime is 34 minutes System returned to ROM by reload at 18:47:11 aa Mon Sep 11 2006 System restarted at 19:02:39 aa Mon Sep 11 2006 System image file is "flash:c2691-adventerprisek9-mz.124-9.T1.bin" Cisco 2691 (R7000) processor (revision 0.1) with 196608K/65536K bytes of memory. Processor board ID JPE080314B5 R7000 CPU at 160MHz, Implementation 39, Rev 3.3, 256KB L2 Cache

2 FastEthernet interfaces 2 Serial(sync/async) interfaces DRAM configuration is 64 bits wide with parity disabled. 55K bytes of NVRAM. 125440K bytes of ATA System CompactFlash (Read/Write)

Configuration register is 0x2102

Reply to
yuriy
Loading thread data ...

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.