RDP thru Cisco VPN client and thru 501 Failure

curttampa · 2008-08-05T19:52:00+00:00

=46rom home, we use plain old home Netgear routers to connect up to thenet. We use our laptops and the Cisco VPN client to connect up to aCisco VPN Appliance in a data center and MS=92s RDP to connect up to ourservers. This setup works perfectly. We use a PIX 501 from our officeto connect to the net. The VPN Client connects up to the applicancejust fine. However, RDP will not connect up to our servers. We areusing a 172.16.1.x sub net within the data center. In the office, wejust a 192.168.4.x subnet. Anyone have any other ideas that mightexplain this failure?Thanks in advance. (Our =91expert=92 who setup all these is unable toexplain it)

Aug 05, 2008 21 Replies

Rate this thread:

Merv 17 years ago

I see the config has nat traversal configured

Hopefully some of the PIX experts on this group will see the posting of your PIX config

You might want to reposting the PIX config if you do not get any feedback on it.

Vote

Shauna 17 years ago

Have you looked at the logs on the PIX? RDP traffic to the servers may be denied from an internet connection.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required