I'm having a problem using the show commands on a WS-4003 switch. When I telnet to the switch, the show command will not produce any results. It just hangs. I have to open multiple telnet sessions, and finally on the 4th or 5th session, I can get the show command to work.
Of course the console works fine.
Any thoughts?
WS-C4003 Software, Version NmpSW: 4.5(1) Copyright (c) 1995-1999 by Cisco Systems, Inc. NMP S/W compiled on Mar 29 1999, 15:49:45 GSP S/W compiled on Mar 29 1999, 10:56:40
System Bootstrap Version: 4.4(1)
Hardware Version: 1.5 Model: WS-C4003 Serial #: JAB03210A10
Mod Port Model Serial # Versions
--- ---- ---------- --------------------
---------------------------------
1 0 WS-X4012 JAB03210A10 Hw : 1.5 Gsp: 4.5(1.0) Nmp: 4.5(1)
2 48 WS-X4148 JAB0309060W Hw : 1.5
3 48 WS-X4148 JAB031108YC Hw : 1.5
DRAM FLASH NVRAM Module Total Used Free Total Used Free Total Used Free
------ ------- ------- ------- ------- ------- ------- ----- -----
-----
1 32768K 16711K 16057K 12288K 3759K 8529K 480K 132K
348K
Uptime is 49 days, 8 hours, 21 minutes