MCI Datacenter handoff connected to Cisco 2950 Switch

I just aquired a cisco 2950 switch for our datacenter. We previously had a low end linksys switch which worked ok. When I switched the line that comes from the datacenter switches I get no link on the port. The link coming in is a 10 baseT. We got a tiered T1 1536 mbps bandwidth. It works fine with the other switch. Any ideas? I only need this switch to do layer 2. Is there any special configuration I need to configure on that port?

Thanks in advance.

Reply to
Loading thread data ... Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.