crashes on 2801with 12.4(15)XZ

Jun 21, 2008 4 Replies
J

Since I have installed 12.4(15)XZ on my 2801, some 3 weeks ago, I am having



2-3 crashes every 24 hrs. When I look in the sh ver, I see: System returned to ROM by bus error at PC 0x61DC9624, address 0xB0D0B29 At every crash I see the same error as stated above. Does any body has a clue what is going on here ?

Thanks, John


Vote
Twitter Facebook LinkedIn
M

Typically bus errors are caused by faulty hardware or software defects (bugs)

I assume your router was functional with the previous release, thus the most likely explanation is that the new version of IOS you loaded is faulty

Why did you upgrade to this particular IOS version ?

I would suggest trying a 12.4 mainline or 12.4 T stream IOS version to see if same issue is encountered

12.4(19)b 12.4(15)T5
Vote
Twitter Facebook LinkedIn
J

Thanks,Merv. I upgraded to this because to check out the new functions on CME 4.3 (CUCME 4.3). And you are right, in the previous IOS I had no problems at all. If you have any more help, I would appreciate it very much ! John

Vote
Twitter Facebook LinkedIn
M

berichtnews: snipped-for-privacy@e53g2000hsa.googlegroups.com...

If you need to use that particular IOS version, then open a case with the Cisco TAC

Vote
Twitter Facebook LinkedIn
J

snipped-for-privacy@e53g2000hsa.googlegroups.com...

There could be an issue with the memory as well... The new code may be using more memory. Memory that may not have been used in the old version of code. Merv is right though - open a case with Cisco... see if they can identify the bug (or possible hardware issue).

JC

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required