Cisco J1 or J2 antenna connector

If you have only one antena, you should plug it to J1 connector. If you have two antenas (or two cables from one antena) - use both connectors. In case of one antena connector you should specify in the configuration that you use one connector.

Good luck,

Mike

snipped-for-privacy@gmail.com schrieb:

...make any difference, as long as the card uses antenna diversity. The card automatically selects the better port, which usually is the one with an antenna connected ;-)

You can also select an antenna port for RX and TX. The terms "left" and "right" are a little misleading, as you can look onto your card from different directions. Sometimes "left" and "right" are referred as "primary" and "secondary". J1 is "primary".