no named access-liosts on router 836!?

Question

hi @all,i wanted to create some named ACLs the following way:hostname (config)# ip access-list ...--------------------------------------------------------------------ROUTER(config)#ip ?    Global IP configuration subcommands:  accounting-list       Select hosts for which IP accounting information is                        kept  accounting-threshold  Sets the maximum number of accounting entries  accounting-transits   Sets the maximum number of transit entries  address-pool          Specify default IP address pooling mechanism  alias                 Alias an IP address to a TCP port[...]------------------------------------------------------------------------unfortunately it semms that my IOS 12.2 for my router 836 doesn't supportthat - even though my book says that all IOS above 11.3 would support that.can someone plz tell me where the prob is?tia elmar

Doan · Accepted Answer

Try typing just access-list.Doan

rave · Answer

plz send the show version of the router.there should be no reason why it should not support it.

elmar bschorer · Answer

hi @all,i wanted to create some named ACLs the following way:hostname (config)# ip access-list ...--------------------------------------------------------------------ROUTER(config)#ip ?    Global IP configuration subcommands:  accounting-list       Select hosts for which IP accounting information is                        kept  accounting-threshold  Sets the maximum number of accounting entries  accounting-transits   Sets the maximum number of transit entries  address-pool          Specify default IP address pooling mechanism  alias                 Alias an IP address to a TCP port[...]------------------------------------------------------------------------unfortunately it semms that my IOS 12.2 for my router 836 doesn't supportthat - even though my book says that all IOS above 11.3 would support that.can someone plz tell me where the prob is?tia elmar

elmar bschorer · Answer

well, seems that this doesn't do the trick. ROUTER(config)#access-list ?              IP standard access list           IP extended access list         Extended 48-bit MAC address access list         IP standard access list (expanded range)           Protocol type-code access list         IP extended access list (expanded range)           48-bit MAC address access list  dynamic-extended  Extend the dynamic ACL abolute timeras far as i can see i can not define a access-list-name :-(

elmar bschorer · Answer

ROUTER#sh verCisco Internetwork Operating System Software IOS (tm) C836 Software (C836-K9O3Y6-M), Version 12.2(13)ZH2, EARLY DEPLOYMENTRELEASE SOFTWARE (fc1)Synched to technology version 12.2(14.5)TTAC Support:  (c) 1986-2003 by cisco Systems, Inc.Compiled Tue 22-Jul-03 09:16 by ealyonImage text-base: 0x800131E8, data-base: 0x80B8036CROM: System Bootstrap, Version 12.2(11r)YV, RELEASE SOFTWARE (fc1)ROM: C836 Software (C836-K9O3Y6-M), Version 12.2(13)ZH2, EARLY DEPLOYMENTRELEASE SOFTWARE (fc1)ROUTER uptime is 0 minutesSystem returned to ROM by power-onSystem image file is "flash:"CISCO C836 (MPC857T) processor (revision 0x200) with 29492K/3276K bytes ofmemory.Processor board ID AMB073103XU (1678418461), with hardware revision 0000CPU rev number 7Bridging software.Basic Rate ISDN software, Version 1.1.1 Ethernet/IEEE 802.3 interface(s)1 ISDN Basic Rate interface(s)1 ATM network interface(s)128K bytes of non-volatile configuration memory.12288K bytes of processor board System flash...

no named access-liosts on router 836!?

Join the Discussion

Didn't find your answer?