Dear ALL:
I have one question with the following situation:
There are 3 VLANs set up in Catalyst 4510. VLAN 1,2,3
There are security consideration with VLAN access:
The requirement is following:
VLAN 1 can visit VLAN 2; VLAN2 can not access VLAN 1
Can Catalyst realize this function, If yes, how?
Thanks for any help
Yes, this feature is named "access-list".
:-)))
And seriously, if you have VLANs you need to communicate between, you have to use Layer3 functionality - create IP and/or IPX interfaces for VLANs and enable IP&IPX routing on the switch. And then you define, which IP Subnet can communicate to which, which traffic is allowed and which not, etc.
Good luck,
Mike CCNP, CCDP, CCSP, Cisco Voice, MCSE W2K, MCSE+I, Security+, etc. CCIE R&S (in progress), CCIE Voice (in progress)
------ Headset Adapters for Cisco IP Phones
Even an older numbered access list would do.
headsetadapter.com wrote:
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.