Greetings,
I just started the above listed switch and cannot access the setup command. The switch starts to switch> the goes to EN but I cannot add ip address to interfaces etc. Any help?
Thx KenZ
4506 SupEng V IOS 12.2(25)EWA4 - Unable to Configure
Feb 20, 2007
3 Replies
did you enter "ip routing" ?
skrev i en meddelelse news: snipped-for-privacy@v33g2000cwv.googlegroups.com...
Are you trying to assign the ip address to the interface acting as switchport? You can assign ip address on a routed port or interface vlan. To convert a switchport to a routed port, enter "no switchport" on the interface that you want to assign ip address. After then, you can assign the ip address to the interface.
pshan
That did it!
Thx
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required