Hi guys, does any one know how to upgrade the EtherSwitch service modules software without effecting the router IOS?
When I go to the switch module, via the "service-module gi2/0 session"
command I get the following;
The system is not configured to boot automatically. The following command
will finish loading the operating system
software:
boot
switch:
switch: boot
Loading "c3750-ipbase-mz.122-25.EZ"...c3750-ipbase-mz.122-25.EZ: no such
device
Error loading "c3750-ipbase-mz.122-25.EZ"
Interrupt within 5 seconds to abort boot process.
Loading "flash:/miragenet"...###########
File "flash:/miragenet" uncompressed and installed, entry point:
0x711b0
executing...
CPU: IBM PowerPC 405/Yeti: clock 125 (MHz)
DRAM: 128MB (0x8000000 Bytes)
Diagnostic Monitor for TEST, Version 1.1.1(44) Compiled by bbuu on Tue
28-Jun-05 09:39
diagmon 1 >