i=B4m having a problem with the above configuration which nobody has been able to help me.
the following is my configuration
Router 2811
IOS:C2800NM-ADVIPSERVICESK9-M, Version 12.3(14)T
Configuration: ## not sure if these are needed? vpdn enable
vpdn-group pppoe request-dialin protocol pppoe ################################
interface FastEthernet0/0 ip address 10.10.10.1 255.255.255.0 ip nat inside ip tcp adjust-mss 1452 duplex auto speed auto no cdp enable no shutdown
interface ATM0/0/0 no ip address no atm ilmi-keepalive dsl operating-mode auto no shutdown
interface ATM0/0/0.1 point-to-point pvc 0/35 pppoe-client dial-pool-number 1
interface Dialer1 ip address negotiated ip mtu 1492 ip nat outside encapsulation ppp ip tcp adjust-mss 1452 load-interval 30 dialer pool 1 dialer-group 1 dialer persistent no cdp enable ppp authentication chap pap callin ppp chap hostname &&&&&&&&&& ppp chap password 12345678 ppp pap sent-username &&&&&&&&&& password 12345678
ip classless ip route 0.0.0.0 0.0.0.0 Dialer1
ip nat inside source list 1 interface Dialer1 overload
access-list 1 permit 10.10.10.0 0.0.0.255 dialer-list 1 protocol ip permit
When I turn on the debugging, I can confirm that the wic does train successfully (SHOWTIME result) with the dslam at the operator.
BUT!!!! When I turn on ppp debugging nothing happens. This tells me that there is a problem within the dialer I think.
I have also confirmed with the operator which dslam they are using (there=B4s being an alcatel), since I have read that only certain ones are compatible with the wic-1adsl. Our operator does for example also use the siemens one which is not compatible