Hi all
I can see the topic has been brought up below, however i do not find any conclusions in the discussion:
Studying for my CCNA, i would very much like being able to make a "Router on a stick" for the purpose of routing between Vlans. I have searched the IOS download at Cisco.com to the point of getting insane, but i can not seem to find any version that fits my 2611 with 8 mb flash and 32 mb ram.
Can 802.1q trunking be done on this config? If so - what (downloadable) IOS should i use?
My current (and not trunk-able) config is below:
I would really apreciate any help!
Best rgds
/Towli - Denmark
2600-50#sh ver Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-I-M), Version 12.3(24a), RELEASE SOFTWARE (fc1) Copyright (c) 1986-2007 by cisco Systems, Inc. Compiled Tue 18-Dec-07 19:01 by stshen Image text-base: 0x80008098, data-base: 0x80CF00A4
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
2600-50 uptime is 25 minutes System returned to ROM by power-on System image file is "flash:c2600-i-mz.123-24a.bin"
cisco 2621 (MPC860) processor (revision 0x102) with 28672K/4096K bytes of memory. Processor board ID JAD043108IZ (2932815247) M860 processor: part number 0, mask 49 Bridging software. X.25 software, Version 3.0.0.
2 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102 --More--
2600-50#