repeater problem with wap11

Nov 25, 2004 2 Replies
R

I have a wap11 v2.2 flashed with dwl-900AP+ firmware. Seems to work ok. But I am testing the repeator function and it doesn't seem to be working.



I have a belkin 54g router. I try to repeat that router with the same ssid and installing the correct mac address. I get a much better signal and can connect but get no internet....



Any ideas? Is it because one is a 802.11g signal and the other 802.11b. I know this is not a "same product" setup but was wondering if any one had done some setups like this.


Vote
Twitter Facebook LinkedIn
N

I had a similiar problem where I had a strong wireless signal, but could not connect to the internet.

This worked for me:

On the wireless computer: Go to Control Panel / Network and bring up the TCP/IP Properties for your Wireless card. Go to the DNS Configuration Tab and select Enable DNS. For the Host Name, I have CTED5 and I had to add the following two IP addresses:

198.6.1.1 204.177.32.2

These are UUNet IP address. I am not sure if they are unique to your ISP, but I think they will get you on the net.

Vote
Twitter Facebook LinkedIn
B

maybe this will help?

formatting link
Bill M.

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required