Hello.
I had a 2216 installed as a supervisor set, with 2 AOMs programmed with agent keys. The set experienced some problems, so we swapped it out, and now the AOMs don't work. Lamps don't flash when the set is plugged in, nothing. The sets were both rls 1. Any ideas?
Jeff
maybe the new phones card is not connected inside?
Release 1 sets I believe needed external power for AOM but there was a clever mod you could do to the set to avoid it. That is, if memory serves correctly I haven't seen a set that old in about 10 years.
Got it figured. The set I had used to replace had a TN ID of M2216ACD-1, and the set it replaced was a M2216ACD/A. Both Rls 01, but different sets altogether.
Thanks
Jeff
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.