HCM06 Problem

Jan 02, 2006 1 Replies

Most relevant reply

CB_Avatar

I figured out a solution, in case others have this problem. I plugged an old CP290 into an outlet on the circuit and a few feet away, and the dimmer responded. That's all it took to set the code, and the CM controller now toggles the light switch.

Read the full reply

My Leviton HCM06-1SW dimmer no longer works (it has worked for over a year). I tried to reprogram, and the LED flashes indicating it will accept a code. However, it does not accept a code. All other units work fine from my CM11A controller. Is there a way to reset this so that it works again, or is it good for the trash?



Thanks!



I figured out a solution, in case others have this problem. I plugged an old CP290 into an outlet on the circuit and a few feet away, and the dimmer responded. That's all it took to set the code, and the CM controller now toggles the light switch.

CB_Avatar wrote:

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required