Cisco Systems

Deny all foreign IP traffic using Cisco PIX 501

Thank you all for your time and assistance. I am looking for a simple solution, whereby our Cisco PIX 501 can be config...

5 comments posted 18yrs

posted by igotlotsofspace

5 comments posted 18yrs posted by igotlotsofspace

PIX 501 client VPN

Hi guys, I have configured Client VPN with the following configuration: PIX501(config)# wr term Building configuration....

4 comments posted 18yrs

posted by dandashi

4 comments posted 18yrs posted by dandashi

cisco 340AP: Failed "Too Many Stations in BSS"

Following cisco's instructions at: http://www.cisco.com/en/US/products/hw/wireless/ps441/products_tech_note09186a008009...

6 comments posted 18yrs

posted by tg

6 comments posted 18yrs posted by tg

RIP on IOS

HI, Can anybody tell how RIP is working on cisco router. Q. how RIP is sending and receiving routing information contai...

2 comments posted 18yrs

posted by rah21111111

2 comments posted 18yrs posted by rah21111111

Multiplexing algorithms implemented in the CISCO ATM switches

I am now studying the cell multiplexing algorithms in ATM. The most relevant paper I have managed to find regarding the...

1 comments posted 18yrs

posted by Aleksey.M.Panov

1 comments posted 18yrs posted by Aleksey.M.Panov

Cisco ASA L2 Decode Drops

Hi All, I have a Cisco ASA running (7.2.3) and am encountering on one of the interfaces, L2Decode Drops. This interface...

0 comments posted 18yrs

posted by jackwik

0 comments posted 18yrs posted by jackwik

Cisco 1811 Router VLAN Question

Hello, I have a Cisco 1811 IOS 12.4(6)T11. It has two L3 ports and eight L2 ports. Is it possible to use the L2 ports f...

6 comments posted 18yrs

posted by tdenham735

6 comments posted 18yrs posted by tdenham735

Cisco 877W of 857W ?

Hi, I will set up a site-to-site VPN between our main site and our "small" department a few miles away. Currently there...

0 comments posted 18yrs

posted by me

0 comments posted 18yrs posted by me

Cisco ASA 5505 split tunneling enabled, still can't ping

I set up a Cisco ASA 5505 for remote access, and a point to point to a colocation facility. Recently local lan access w...

0 comments posted 18yrs

posted by meanmotorscooter

0 comments posted 18yrs posted by meanmotorscooter

bringing the internet down redistributing rogue BGP routes

I was just looking at following scenario: Some one or an rogue organisation builts up an ISP, which is multihomed over...

5 comments posted 18yrs

posted by colin.cant

5 comments posted 18yrs posted by colin.cant

Is there a "dry run" mode for access lists before apply

Hello all, I'm relatively new in Cisco administration, so if my question seems to be evident, or if the answer is alrea...

2 comments posted 18yrs

posted by andrerodier

2 comments posted 18yrs posted by andrerodier

2621 and pix how to find bandwidth abuser

I have about 200 users on 2 subnets 192.168.1.x and 192.168.5.x they all go to a 2621 router that forwards all but thes...

3 comments posted 18yrs

posted by estctech

3 comments posted 18yrs posted by estctech

14 Hex Characters in a MAC Address?

I've noticed that a few of the devices I have on my network have fourteen character MAC addresses. As the material I st...

4 comments posted 18yrs

posted by fatkinson

4 comments posted 18yrs posted by fatkinson

PIX 501 Disconnecting

I am new to configuring Cisco routers. I have manage to get a PIX 501 setup and the VPN working. The problem I am havin...

0 comments posted 18yrs

posted by karlman68

0 comments posted 18yrs posted by karlman68

L2TPv3 support on 3640

Is L2TPv3 supported on 3640 (IOS 12.3(14)T7)? I tried a test net with two 3640s connected via a crossover cable. The tu...

1 comments posted 18yrs

posted by pfisterfarm

1 comments posted 18yrs posted by pfisterfarm