How can i shape the interface of an cisco 3560 not to allow more than
2mbit of outgoing and ingoing traffic?Jo Christian Buvarp
Traffic shaping 3560
Oct 02, 2006
4 Replies
Try: storm-control unicast bps 2000000
You can't traffic shape with a 3560 , only Police. If you want shaping you would need to do it with a router.
Le> Jo Christian Buvarp wrote:
How can i shape the interface of an cisco 3560 not to allow more than
2mbit of outgoing and ingoing traffic?
Jo Christian Buvarp
Use srr-queue. It uses a percentage based type of algorithm. You will need to hard set both devices to 10/Full to go down that low. Lowest percent you can go is 10, so the only way to get to 2M using ssr-queue is hard seting to
10M/Full.interface FastEthernetX/X speed 10 duplex full srr-queue bandwidth limit 20
20% of 10M = 2MThis sets the egress bandwidth so you will also need to set it on the other port you are trying to limit.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required