Hi, I have a Cisco PIX 515 with an 7.0(5) image. There is no config on the Pix. When I use the setup to configure the internal ip address, hostname and the domain (for example), save the configuration an reboot the pix, it say's during startup that it can't find an image to load an immediately reboots. Hope someone can help.
regards Holger
Before you reboot the PIX, do you see a line similar to:
boot system disk0:/asa721-k8.bin
Yours will probably boot system disk0:/asa705-k8.bin on yours but that line is relevant. Are you copying the running config to the startup config?
HTH
This may also help you as well:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required