1. Home
  2. Cisco Systems
  3. PIX 520 - Routing external subnet?

PIX 520 - Routing external subnet?

Hi everyone,

Is it possible to route an external subnet with a pix 520, 3xNIC.

This is what i would like to do.

We have a set of ip addresses routing to our media converter. From here, one of those addresses has another subnet routed to it.

Is it possible to set ethernet0 to the main eternal address (single ip), ethernet2 to the alternate subnet (multiple ip's) {where i could then plug some external servers} and ethernet1 as an internal/ firewalled network NATing one of the IPs of etnernet2 (the alternate subnet)?

If you could post some config lines that would be excellent!

Thanks, Jack

Reply to
Jack
Loading thread data ...

Take a look at this Cisco doc

Configuring PIX Firewall with Mail Server Access on the DMZ

formatting link

The DMZ is where you would place your servers

Reply to
Merv

Is it posible to have the DMZ's ip addresses externally routable?

i.e: could i put another router on the DMZ with one of the external IP addresses and NAT again?

Thanks, Jack

Reply to
Jack

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.