[new user]

Hello folks, it's first time that I use a cisco 801 and my boss wants the work the newt week. So, I need help.

Some days ago I loaded on my windows machine rhe "cisco fast step" and I guessed for a new machine using the coinsolle cable.

The cisco software found the cisco 801 bu ask me the old password... this is an old machine that my boss gave to me to progamming again the machine so I can also reset all data into this cisco, otherwise I can try with default user and password.

Can you help me? What are the factory user name, read password and read/write password? How can I reset the machine?

Thank you very much.

Reply to
myname
Loading thread data ...

Here is Cisco's password recovery procedure for the 801 et al:

formatting link
Regards, Steve
formatting link

Reply to
www.networking-forum.com

Thanks but it don't work :(! I'm using Windows Hyperterminal and the key breack and SHIFT-F6 to get the break command.

It's what I can see after 60 seconds... (when I press break the state is freezed... no more events...)

01:17:39: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

01:18:39: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

TinyROM version 1.4(1)

19:37 11/07/00 Copyright (c) 1998-2000 by cisco Systems, Inc.

All rights reserved.

POST ............ OK. 4MB DRAM, 8MB Flash.

Configured boot failed, attempting fallback boot.

Booting "c800-y6-mw.122-8.T5.bin" ..., Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth i (c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support:

formatting link
(c) 1986-2002 by cisco Syst Compiled Fri 21-Jun-02 11:25 by ccai Image text-base: 0x000F5000, data-base: 0x0077F000

Cisco C801 (MPC850) processor (revision 1) with 44156K bytes of virtual memory.

Processor board ID JAD064000RM (366422497)

CPU part number 0x2101 Bridging software. Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s) 1 ISDN Basic Rate interface(s) 4M bytes of physical memory (DRAM) 8K bytes of non-volatile configuration memory

8M bytes of flash on board (4M from flash card)

Press RETURN to get started!

00:00:23: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up

00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to up

00:00:28: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state

to down

00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed state

to down

00:00:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:32: %SYS-5-CONFIG_I: Configured from memory by console

00:00:33: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support:

formatting link
(c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 21-Jun-02 11:25 by ccai

00:00:33: %SNMP-5-COLDSTART: SNMP agent on host router is undergoing a cold star t 00:00:34: %LINK-3-UPDOWN: Interface BRI0, changed state to up

00:01:38: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

00:02:38: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

TinyROM version 1.4(1)

19:37 11/07/00 Copyright (c) 1998-2000 by cisco Systems, Inc.

All rights reserved.

POST ............ OK. 4MB DRAM, 8MB Flash.

Configured boot failed, attempting fallback boot.

Booting "c800-y6-mw.122-8.T5.bin" ..., Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth i (c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support:

formatting link
(c) 1986-2002 by cisco Syst Compiled Fri 21-Jun-02 11:25 by ccai Image text-base: 0x000F5000, data-base: 0x0077F000

Cisco C801 (MPC850) processor (revision 1) with 44156K bytes of virtual memory.

Processor board ID JAD064000RM (366422497)

CPU part number 0x2101 Bridging software. Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s) 1 ISDN Basic Rate interface(s) 4M bytes of physical memory (DRAM) 8K bytes of non-volatile configuration memory

8M bytes of flash on board (4M from flash card)

Press RETURN to get started!

00:00:23: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up

00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to up

00:00:28: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem?

00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state

to down

00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed state

to down

00:00:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:32: %SYS-5-CONFIG_I: Configured from memory by console

00:00:33: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support:

formatting link
(c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 21-Jun-02 11:25 by ccai

00:00:33: %SNMP-5-COLDSTART: SNMP agent on host router is undergoing a cold star t 00:00:34: %LINK-3-UPDOWN: Interface BRI0, changed state to up

TinyROM version 1

19:37 11/07/00 Copyright (c) 1998-2000 by cisco Systems, Inc.

All rights reserved.

POST ............ OK. 4MB DRAM, 8MB Flash.

Configured boot failed, attempting fallback boot.

Booting "c800-y6-mw.122-8.T5.bin" ..., Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1)

TAC Support:

formatting link
(c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 21-Jun-02 11:25 by ccai Image text-base: 0x000F5000, data-base: 0x0077F000

Cisco C801 (MPC850) processor (revision 1) with 44156K bytes of v

Processor board ID JAD064000RM (366422497)

CPU part number 0x2101 Bridging software. Basic Rate ISDN software, Version 1.1.

1 Ethernet/IEEE 802.3 interface(s) 1 ISDN Basic Rate interface(s) 4M bytes of physical memory (DRAM) 8K bytes of non-volatile configuration memory

8M bytes of flash on board (4M from flash card)

Press RETURN to get started!

00:00:23: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up 00:00:24: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta te to up 00:00:28: %PQUICC-1-LOSTCARR: Unit 0, lost carrier. Transceiver problem? 00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, changed state to down 00:00:28: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:2, changed state to down 00:00:29: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta te to down 00:00:32: %SYS-5-CONFIG_I: Configured from memory by console 00:00:33: %SYS-5-RESTART: System restarted -- Cisco Internetwork Operating System Software IOS (tm) C800 Software (C800-Y6-MW), Version 12.2(8)T5, RELEASE SOFTWARE (fc1) TAC Support:
formatting link
(c) 1986-2002 by cisco Systems, Inc. Compiled Fri 21-Jun-02 11:25 by ccai 00:00:33: %SNMP-5-COLDSTART: SNMP agent on host router is undergoing a cold star t 00:00:34: %LINK-3-UPDOWN: Interface BRI0, changed state to up

THANKS

Reply to
myname

it is CTRL-BREAK key in hyperterminal not just BREAK = Pause = freeze the whole thing

formatting link
good luck mate

Reply to
polleke7

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.