New to Cisco

The server I am trying to reach is on the PIX network and has that device set as the default gateway. That was I thought originally was the problem. The two firewalls are on separate lines and have separate public interfaces. I am able to get to the outside from behind the PIX from the server and my machine. I am pretty sure that the watchguard isn't effecting the other firewall.

Ken,

Try this, issue a 'show xlate' command, it will list current translations in the NAT table, in the list look for an entry such as:

PAT Global External IP(443) Local 10.0.1.200(443)

This will tell us if it is a NAT issue or an ACL issue

I have port 25, 1045, 1044, 1041, 1040, 1031 but no 80 or 443. Which could be a problem.

Ah!

I assume you have some extra IP address? If so could you try this...

access-list outside_access_in_1 permit tcp any host eq 25

access-list outside_access_in_1 permit tcp any host eq 80

access-list outside_access_in_1 permit tcp any host eq 443

then place these:

static(inside,outside) tcp smtp 10.0.1.200 smtp netmask 255.255.255.255

static(inside,outside) tcp 80 10.0.1.200 80 netmask

static(inside,outside) tcp 443 10.0.1.200 443 netmask 255.255.255.255

access-group outside_access_in_1 in interface outside

Before doing this remove any existing ACL or static statements, also remove the nat (inside) 0 inside_nat0 statement.

You can simplify and do a full static (all ports) if you have available IPs on the outside.

static (inside,outside) 12.190.141.214 10.0.1.200 netmask

Then clear xlate and see what IP your web server is using with a tool like whatsmyip.

It should report that the web server is at 12.190.141.214. I assume the web server is working on the inside, so not a web server problem, and that it is listening on port 80 for the IP of 10.0.1.200.