I have a Cisco 1120 and a Cisco1200AP, I need to reach a computer on the other side of the office. Can I connect the two ap's as a bridge and connect the computer to the remote ap? Is there any example config for this setup.
Thanks
Connect 1100 and 1200 ap as a bridge
Nov 12, 2007
1 Replies
see Cisco TAC doc "How to configure a Cisco AP as a wireless bridge"
formatting link
You need to place one of the AP's radio into universal mode ( i.e. non- root bridge)
If you have a coverage problem it might be better to put in cabling to the second AP and used it as a regular AP
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required