to set up power transmission of AP

hello to all, I have a Pci card with chip Prism2 installed on a mother board for device embedded, have installed the hostAP driver in order to make it to work as AP... but I would have needs it to control and to manipulate via software and in realtime the power of transmission in dB... someone knows to say me if it is possible to make it and if some software exists already eventually to adapt

thanks, Salvo

Reply to
salvodi
Loading thread data ...

The transmission power will be controlled by the chip that your using. You might need an amplifier if that doesn't work.

Doug

Reply to
Doug Simar

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.