HI,
I am still very new to this technology. All this lab is on an internal LAN.
X-Lite Software Telephone - 172.16.130.106 Cisco Fast Ethernet - 172.16.130.248 Cisco BRI connected to the ISDN Line Simulator with numbers 384001 and
384002.
I've seen and searched for several scenario's etc. I have a doubt as some articles quote that I should use a SIP Proxy as well (like OnDo Sip Proxy) and some quote that the cisco router can do all the routing /authentication.
Any Idea from where to start such project? Up to now all i managed to do is configure the router (2821) lines etc, but i dont know what i should do more regarding VoIP, authentication and all the rest. Does anyone know of any article/tips or whatever that can help me?
Below is part of the router configuration related to VoIP.
Note: in this particular scenario I was trying to work with a SIP proxy, but still nothing is working and I am not sure if this is the correct way I am working.
isdn switch-type basic-net3 ! voice-card 0 no dspfarm ! voice service voip h323 ! voice class codec 1 codec preference 1 g711ulaw ! voice class h323 1 h225 timeout tcp establish 3 ! interface GigabitEthernet0/0 ip address 172.16.130.248 255.255.255.0 duplex auto speed auto no mop enabled ! interface BRI0/0/0 no ip address isdn switch-type basic-net3 isdn twait-disable isdn spid1 384001 isdn spid2 384002 isdn incoming-voice modem ! dialer-list 1 protocol ip permit ! control-plane ! voice-port 0/0/0 input gain -3 output attenuation 4 echo-cancel coverage 24 no comfort-noise timeouts interdigit 6 ! sip-ua retry invite 2 retry response 2 retry bye 2 retry cancel 2 sip-server ipv4:172.16.130.22
regards,
0TKN3T