1. Home
  2. Voice-Over-IP
  3. Need to implement a "Click-to-Talk"

Need to implement a "Click-to-Talk"

Hi all:

I have a Cisco AS-5300 on which I have configured dial-peers and have done some Tcl IVR programming (rejection of blacklisted numbers based on ANI).

My next project is to implement a Click-to-Talk application which will run on Windows XP clients. More specifically, the application will establish a 2 party session BUT it will not be part of it. I am told this is called "Third Party Call Control" (3PCC).

My basic two problems are:

- Find some Windows SIP client, in commercial SDK form, or even better: OSS.

- Figure out what needs to be configured on the Cisco gateway.

All I have found in the Cisco site is that they indeed support 3PCC, but I have been unable to find any other detail.

The SFLphone

formatting link
looks very promising, but the Windows port is not ready -not even close.

I would be most grateful for any tips, suggestions, URLs, and expertise you can share.

TIA,

-Ramon F Herrera

Reply to
Ramon F Herrera
Loading thread data ...

I must add that I am not looking for a closed-and-ready Click-to-Talk application, I need instead I to add Click-to-Talk functionality to my own application.

-Ramon

Reply to
Ramon F Herrera

Pl. contact to get a sloution

snipped-for-privacy@softswitches.net

Ram> I must add that I am not looking for a closed-and-ready Click-to-Talk

Reply to
appan

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.