Hi
I am designing a High Sampling Rate Digital receiver with following building blocks:
1-ADC is AD6645 105MSPS 14-bit
2-DDC is GC4016, 100 MSPS 4-ch
3-...
To design a good pcb layout for acheiving the claimed specifications of the ADC i decided to use PSD to simulate this Mixed-Mode board. Unfortunately, i am not familiar with this software, and i think it take too much to be familiar with it. My question is: Is it possible to use lower level softwares such as P*otel to do this job?
Professinal answers are welcomed.