It's extremely hard on the eyes durring an intruder alarm state to have your lights flashing... Id love for it to just turn them ON like they do in fire alarm state. Anyone know how to make this happen? None of the option commands seem to address this that I could find.
Thanks for the guidance,
-Brendan
To anyone reading this, GE told me directly that it can't be changed inside the panel; disable X10 or move your lights to unit codes outside of the same housecode. Or, I think.. do some reading in your manual... that it may only flash the lights on unit codes 1-8... possibly moving all light unit codes to high numbers might solve the problem? I didn't go this route; I changed housecodes.
-B
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.