MICS Setup

Aug 01, 2005 1 Replies
N

We are replacing a CICS with a MICS. We are going from 8 lines to 20 lines and from 16 stations to 24 stations. We will be putting a T-1 in later, but not now.



I have worked on MICS before, but have not installed from scratch. I have a couple of questions:


  1. Is there a limit to the number of lines you can put in a line pool?


  1. How difficult is it to install/program the Fiber Trunk Card and



6-Port Expansion Card?


  1. Is there a specific order these cards need to be put in the cabinets in order to work properly?

  2. Any info/warnings I should know before I start?

Any insight would be greatly appreciated.



Thanks! Melinda


Vote
Twitter Facebook LinkedIn
D

Not to my knowledge.

Slide the card n the slot, I believe that a single card goes in the right hand slot.

put the cards in before I power up the system.

On your 6 port expansion card, the trunk modules are connected starting from the bottom, and the station modules start at the top, this keeps line and station numbers in the proper order.

Vote
Twitter Facebook LinkedIn

Join the Discussion

Have something to add? Share your thoughts — no account required.

Didn't find your answer?

Ask the community — no account required