ANI info on DTI (that is, non-PRI T1) on M1 system

Hi, All, I have heard from several sources, including a few statements in the NTPs, that inbound ANI from the network to the PBX should be possible without PRI.

I have an application where I need to get this to work, and I have ready access to the Central Office folks to make sure they are sending the info from their end.

Can anybody tell me what special settings are required in the trunk/route/CDB/whatever to get this to work?

-Samuel Hodgeman

Reply to
Loading thread data ...

I got this to work on a channelized T-1 when set up as E&M with realtime ani enabled. when the call comes in you can monitor and hear the ANI and DNIS come across as DTMF *ANI*DNIS*

Reply to
XBarNone Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.