8 discussions on Cabling-Design.com Forums about the Cisco NM-4E: what owners asked, what went wrong, and what fixed it.
HelloI have a C3620 (16F/64D) IOS 12.3(24) IP/FRW/IDS PLUS that is doing the firewall /nat device for my lan.My network is this:Edge Router C2650"dmz switch" HP Procurve 2512hp switch -> (DMZ/wan side) Eth1/0-----NM4E --{C3620}...
HelloI have a strange problem.I have a C3620 with a NM-4E module and a Cisco 2950T-24 switch.If I connect a port of the NM-4E to a port of the catalyst, the led lights up, the port goes on UP state but no packets get through.If I put a port...
Hi,I have a 2620 that currently routes my local network and connects to theoutside world via ISDN. I'm replacing that with ADSL via an external router(D-Link DSL-502T) and the way that I've been recommended to set it up is tohave the Cisco...
Hi friends,I am just looking for a migration path for Cisco 3640 and CiscoCatalyst 4006 switch.I came to know that a good migration path is :Cisco 3640 ---> Cisco 3745Cisco Catalyst 4006 ---> Catalyst 4510RJust two doubts on the migration...
Hi friends,There is a link that says that NM-4E is suitable for 2600/3600 and 3700series routers. But I came to know from my colleague that it is notsupported on 3725 routers.The link that I got this info from is: someone please confirm on...
I have a Cisco 3640 connected to a Westell ADSL Modem and an AmbitCable Modem/Router. I recently upgrade to 7.0Mb x 768Kb on each. Iused to have 3.0Mb x 768K on ADSL and 2.0Mb x 384K on Cable. Both havestatic IP addresses.When I connect...