3Com Switch 3300

I have two 24-port 3300 switches linked by a crossover cable in Port 24 of each. When I http into the admin page, I can only see Unit 1 (lower MAC address). I have tried disconnecting Unit 1 and only use Unit 2, but I can't seem to get the unit to have it's own IP address.

How can I configure Unit 2?


Reply to
Loading thread data ...
  • Craig :

Connect to the serial console, go into the IP configuration menu (it's several years ago that I worked with them, so names may be different) and configure an administrative IP address of it's own.

Best regards, Daniel

Reply to
Daniel Roesen

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.