Latest threads in Cisco Systemsshow only best voted threads
| Subject | Author | Posted | Replies | |
|---|---|---|---|---|
|
|
PIX VPN
Having trouble establishing PIX VPN with Juniper firewall; I am configuring the PIX - traffic from 1.1.1.1 should establish the VPN... Juniper Proposals are ESP 3DES HMAC SHA1 (IKE) =96 Juniper:...
2
|
13 years ago
|
2 | |
|
|
PIX 515E Changing from DSL to Cable ISP
IOS Version 6.2 I cannot access the internet using my new cable modem and the settings below. I'm not sure the exact amount of static IPs we were allotted by the DSL provider (someone may be able to...
3
|
13 years ago
|
3 | |
|
|
pix 515 version 6.3 vs. 8.0 PAT
Correction.. access-list inbound permit tcp any interface tpfg eq https static (inside,tpfg) tcp xx.xxx.xx.251 https 192.168.1.16 https netmask 255.255.255.255 access-group inbound in interface tpfg
2
|
13 years ago
|
2 | |
|
|
GRE tunnel problem
I have used tunnels quite a lot, with and without keepalives, and this should not be happening - obviously:) I wonder if there is perhaps some routing problem such that the routers cannot communicate...
7
|
13 years ago
|
7 | |
|
|
how to do both PPTP and L2TP/IPsec
In the meantime I got it working by using "l2tp security crypto-profile" instead of a static crypto map with match address.
1
|
13 years ago
|
1 | |
|
|
1911 cisco router
I got 1911 cisco router.. and unfortunately one of my co worker has configured it without username and password.. he did configure enable password but now on boot up it is asking for username and...
2
|
13 years ago
|
2 | |
|
|
Pix 515 Configuring Multiple External Interfaces
I have a total of 3 physical interfaces. 2 of them external and one internal. One external interface ip is xx.xx.xxx.251. The other external interface ip 192.168.3.3. The internal interface ip is...
—
|
13 years ago
|
— | |
|
|
spammng diagnostic logs
These are not the logs you are looking for. None of them are to a destination port of 25.
5
|
13 years ago
|
5 | |
|
|
Blocking Audio Streaming
Hi, I'm trying to block my users to stream radios, I have found this post regex audio-mpeg "audio/.*" policy-map type inspect http test_radio parameters protocol-violation action drop-connection log...
—
|
13 years ago
|
— | |
|
|
pix 515 version 8.0(2) Internal Interface
Please, refer to the configuration found below. I have two external interfaces and one internal. At least, I should be able to ping the internal interface from local network, but it is not happening....
1
|
13 years ago
|
1 | |
|
|
3745 IOS
| I have a 3745 running off xmodem download. I need to get IOS ontop | flash: or slot0: so I can restart as normal. If I try to "TFTP: flash: | (or slot0:)" from my TFTP server it always fails at the...
2
|
13 years ago
|
2 | |
|
|
Spa9000 Sip to IAD2431 to Cisco 2811 PRI
internal SIP based system consisting of SPA9000, SPA400 and SPA942 phones is to be configured to send and receive calls through a PRI based protocol set up on the carrier edge router Cisco 2811. I...
—
|
13 years ago
|
— | |
|
|
How-to configure a free NetFlow forwarder or NetFlow duplicator
How-to configure a free NetFlow forwarder or NetFlow duplicator: Cisco How-To Tutorials http://www.bradreese.com/cisco-how-to-tutorials.htm http://www.bradreese.com/blog/plixer-5-21-2010.htm
—
|
13 years ago
|
— | |
|
|
Quick Best Practices question on VLANs
This is my setup: Dirty traffic ---> firewall interface on VLAN100 ---> filtered traffic to VLAN200 --- server interface on VLAN200. Both VLANs are on the same physical switch. I seem to recall from...
2
|
13 years ago
|
2 | |
|
|
No tftpdnld command
I appear to be totally stuck with a 3725. My compact flash is missing - there is no image in flash and ROMMON doesn't have a TFTPDNLD command. I tried to boot from tftp - that failed as well... rommon...
9
|
13 years ago
|
9 |