1. Home
  2. Cisco Systems
  3. Troubleshooting Up/Down Serial Link PPP Encapsulation

Troubleshooting Up/Down Serial Link PPP Encapsulation

There are two routers connected via a T1. The corresponding interface on each router is int an up/down state. The encapsulation on both ends is PPP. A sh int on the DTE side shows:

DCD=up DSR=up DTR=up RTS=up CTS=up

A sh int on the DCE side shows

DCD=up DSR=up DTR=down RTS=down CTS=up

So the only difference is that DTR and RTS are down on the DCE side. What could this mean? What would be the best steps to troubleshoot? Thanks for any help.

Reply to
<bob
Loading thread data ...

On the DCE interface add the command: clock rate 64000

Reply to
the_jonesboys_posse

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.