Hello,
I have been asked to supply the serial number for some 7600s - so they can be explicitly identified for insurance purposes and a bit later for service contract. Not quite sure what might meet this requirement - is there a serial ID physically fixed to the box. Might the MAC address be OK or something else -possibly queried by telnet (or SNMP).
TIA
JJ
try "show hardware" at a console session
probably - but your biggest issue is likely to be which serial number, since every item that could be swapped by an engineer has one, some of the daughter cards etc.......
there are a variety of commands that may give you the info you are looking for
show version
show hardware
show inventory
show module
show diag
show idprom backplane
There will be a serial number for the chassis affixed somewhere you need to look at one and them match up the output from the above commands
the will be a chgassi serial number and there will be a module serila number for each o the cards in the chassis along with power supplies etc
Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.