1. Home
  2. Cisco Systems
  3. if CEF is working ? [ was T1 x 2]

if CEF is working ? [ was T1 x 2]

Thanks to your advice, I am able to config the two routers 1760, each with 2 WIC-1DSU-T1-V2, to connect with each other thru two T1 lines.

From a host on this site I can ping hosts on the other site, no matter

which T1 line is up.

I setup CEF share-loading per-packet. Which command can help me check if the packets are really sent round-robin on these two lines ?

Thanks,

DT

Reply to
dt1649651
Loading thread data ...

Well, throwing a bunch of traffic down the link, and checking on the per-packet and bandwidth usage on all the interfaces in use probably would be a good start.

Reply to
Doug McIntyre

Thanks. I just tried by using traceroute. Running tracroute multiple times, I can see the alternative SE to be chosen.

DT

Reply to
dt1649651

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.