i've got a 2950 switch, 2611 router and 515 pix i want to set them up so that i route different VLANs through the firewall i plan to set the equipment up in this order
----------------------- | | | router | | |
----------------------- | | |
----------------------- | | | pix | | |
----------------------- | | |
----------------------- | | | switch | | |
-----------------------
is this correct?
You cannot route VLANs individually on a PIX, unless you are using
7.x software and VRF (Virtual Router Facility) so that each VLAN sees a different router table. (Though there might be other selective routing mechanisms in 7.x that I haven't happened to encounter yet.)Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.