end to end vpn cisco pix 501

Need a little help please. I am using the pdm on a pix 501 to setup/config an end to end vpn with another pix 501. I am using the vpn wizard and I want to make sure I am understanding this. The Peer IP address would be the public ip on the remote pix..correct? The Host/Network(On local site) would be the inside nat address range on the local lan..correct?

And finally the (On Remote Site) Host/Network would be the inside natted address range on the remote side...correct?

Thanks in advance for any help!

Reply to
Loading thread data ...

YES to all.

Reply to
Joe Beasley

Cabling-Design.com Forums website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.