DMVPN and NAT-T

Is this DMVPN scenerio possible?

c2621XM fa0/0 (172.24.2.1/24) > (172.24.2.2/24) Eth0 Digi NAT-T/IPsec passthrough device Wireless: (DHCP Public address) > Internet > Static NAT 172.33.x.1 to 172.24.7.1 > (172.24.7.1) c2600 Hub router

I have the following working ok:

c2621XM spoke (public Static address) > Internet > Static Nat

I have about 15 spokes that are connected this way an it works ok. I do have some issues with the spoke to spoke communication but, since we do not use this much I haven't looked into it too deeply. From the hub I can communicate to these 15 spokes without any issues. My main quesion is the Wireless NAT-T device not going to allow me to connect this way?

I did get the following working:

c2621XM fa0/0 (172.24.2.1/24) > (172.24.2.2/24) Eth0 Digi NAT-T/IPsec passthrough device Wireless: (DHCP Public address) > Internet > Public IP Checkpoint Endpoint.

Any help or suggestions would be appreciated.

Thanks, Travis